|
|
| Figurine of dancer, wearing garment with double hem; material gathered in heavy folds alternating with flatter ones, agitated; lower hem pulled obliquely over lt. shoed foot which partly projects from ... Hellenistic Context probably Roman |
| Miniature implement consisting of a stem or handle, tapering at one end to a narrow point, at opposite end widening and thinning to a broad blade. Possibly a chisel or, alternately, a stylus. Bronze Complete ... Late archaic - early 5th c. BCE |
| Iron knife with thick blade, triangular in section, with straight back, slightly rounded cutting edge, tapering to tip. Probably part of MF-14440A giving total length of knife: 0.253. Iron. Fragment. Single ... 2nd 1/2 5th c. BC, based on context |
| Loomweight with flattened sides giving slightly rectangualr section. Bevel high, rounded, tapering to blunt tip; bottom deeply indented in center; suspension hole 0.074m. above bottom. Profile similar ... Context: late 3rd to early 2nd c. B.C., one Roman sherd |
| Loomweight with slender proportions, high rounded bevel only slightly greater than diameter of bottom, tapering to blunt tip; bottom indented. Suspension hole 0.07 from bottom. Corinth XII profile XI? ... Context: pottery early 4th c. B.C.; loomweight at least 2/2 3rd if not 1/2 2nd c. B.C. |
Large knife blade triangular in section, with straight back, curved cutting edge, curving up to tip. Similar to MF-1970-172 in size and form. Iron. Fragment. Two joining frgts., preserving most of blade ... early 3rd c. BC, based on context. |
| Long broad iron knife, triangular in section with straight back, curved cutting edge rising toward missing point. Iron. Fragment. Two joining frgts., preserving most of blade, broken at either end; badly ... Context 5th-6th c. A.C., knife possibly Roman |
| Conical loomweight, profile VIII, with flat bottom, low bevel, tapering toward tip, suspension hole. stamp. Pointed oval above bevel, with satyr crouching left, an amphora on his back. See MF-2600 (Davidson ... First half of 5th century B.C. |
| Solid sandaled left foot tapering to sharp end above ankle. Foot flat on bottom, toes separated by incisions. Sandal held to foot by straps of applied clay: one encircling the back down to sides, another ... based on context, comparanda late 6th c. BC |
| Flattened spherical hollow rattle with flat resting surface at bottom and loop handle at side. Similar to KV-936 (Stillwell and Benson 1984, Corinth 15.3, cat. 2115).
The rattle is similar to: MF-11909; ... based on context |
| Conical loomweight with flat bottom, low rounded bevel tapering to tip. Horizontal suspension hole ca. 0.018 below tip. Ratio of bevel to height: 10.3% inscribed. Incised on bottom before firing: 2 arcs ... Context: 4th to 6th century A.D. |
Very thin flat oval disk. inscribed. Ligature ENE on line along long axis on one side. Bronze. Complete or intact. Almost complete, chipped on edges ... 1965/03/26 |
| Finger ring with oval bezel. Intaglio decoration in bezel. Seated figure facing three-quarters right, male (?), right arm down at side, left arm bent, forearm extended, resting on left knee, supporting ... at least mid 5th c., based on context pottery |
| Casing for swallowtail clamp, consisting of flat floor, slightly elevated rim on two long sides, H. 0.0065, and deeper rim on narrow end 0.015. Side rims have triangular termination, narrow end flat; ... 6th c. BC? |
| Small solid cylinder with incurving sides. Upper surface is slightly convex, a small shallow knob at center where stem was attached for spinning. Lateral wall of cylinder is slightly convex with seven ... 1965/06/23-1968/06/06 |
| War galley with shallow rounded hull and sloping sides, preserving bow which extends slightly upward to indicate a projecting stem. Pointed flattened ram projects outward and down from hull. Handmade ... Date of context: Middle Roman |
| Head of large dress pin with crowning disc with upturned lip and elaborate finial; below, 4-5 spheres of diminishing size. For parallels in bronze see MF-13151, MF-13185. See Killian-Dirlmeier, Nadeln ... 1965/03/20;1965/04/07 |
| Moderately sized knife with tang handle, rectangular in section; narrow blade, triangular in section with straight back, straight cutting edge curving up towards tip. Iron Fragment. Three joining fragments, ... 1964/09/03;1964/09/08 |
| A small knife blade, triangular in section, with both back and cutting edges tapering uniformly with straight profiles from handle end to tip. Close in size to MF-14415. Iron Fragment. Single fragment ... 1964/02/22;1964/04/11 |
| A somewhat irregularly shaped ring, the orientation of which is not clear. It is higher longer or ‘taller’ than it is wide or wider than high. It is formed by a thin band square in section of uneven thickness, ... 1962/05/30; 1962/06/15
1962 |
|
|
