|
| Loomweight with slender proportions, high rounded bevel only slightly greater than diameter of bottom, tapering to blunt tip; bottom indented. Suspension hole 0.07 from bottom. Corinth XII profile XI? ... Context: pottery early 4th c. B.C.; loomweight at least 2/2 3rd if not 1/2 2nd c. B.C. |
Large knife blade triangular in section, with straight back, curved cutting edge, curving up to tip. Similar to MF-1970-172 in size and form. Iron. Fragment. Two joining frgts., preserving most of blade ... early 3rd c. BC, based on context. |
| Long broad iron knife, triangular in section with straight back, curved cutting edge rising toward missing point. Iron. Fragment. Two joining frgts., preserving most of blade, broken at either end; badly ... Context 5th-6th c. A.C., knife possibly Roman |
| Conical loomweight, profile VIII, with flat bottom, low bevel, tapering toward tip, suspension hole. stamp. Pointed oval above bevel, with satyr crouching left, an amphora on his back. See MF-2600 (Davidson ... First half of 5th century B.C. |
| Solid sandaled left foot tapering to sharp end above ankle. Foot flat on bottom, toes separated by incisions. Sandal held to foot by straps of applied clay: one encircling the back down to sides, another ... based on context, comparanda late 6th c. BC |
| Flattened spherical hollow rattle with flat resting surface at bottom and loop handle at side. Similar to KV-936 (Stillwell and Benson 1984, Corinth 15.3, cat. 2115).
The rattle is similar to: MF-11909; ... based on context |
| Conical loomweight with flat bottom, low rounded bevel tapering to tip. Horizontal suspension hole ca. 0.018 below tip. Ratio of bevel to height: 10.3% inscribed. Incised on bottom before firing: 2 arcs ... Context: 4th to 6th century A.D. |
Very thin flat oval disk. inscribed. Ligature ENE on line along long axis on one side. Bronze. Complete or intact. Almost complete, chipped on edges ... 1965/03/26 |
|
|