|
| Small flase ring foot, flaring sides with slight curve insward at lip. 7 grooves on lower part of side, 2 around center of outside. Zones of design on interior set off by grooves incised through black ... |
| Articulated kantharos. Upper wall only; vertical rim; strap handle with strap thumb rest, from rim to upper body. Fully glazed. Two fine wheel grooves, closely spaced, at handle zone. Fine soft Corinthian ... 275 B.C. or later |
| Kantharos with high ring foot in two degrees, flat resting surface. Short concave stem, body in two degrees offset from stem. Deeper lower section ovoid, upper vertical with concave profile to high ... First half (GRE) |
| Large articulated kantharos with straight tapering body, fine rounded lip. Two thin vertical spurred strap handles on upper body to 00.005 m. below lip. Faint paddling (?) lines on one face in handle zone ... 330-300 B.C. |
| Campanian Fishplate with high, silghtly flaring ring foot, convex resting surface. Deep, straight -flaring body, offset, wide, straight-flaring rim. Oblique, rounded lip. Center of floor depressed ... Hellenistic |
| Chytra with rounded bottom, ovoid body with greatest maximum diameter below median at 0.063. Outward flaring rim joining body with soft articulation. Prominent wheel ridges at articulation. Lip beveled ... 1934/05/22 |
| Kantharos with moulded ring foot: nearly straight flaring with groove near upper edge, nearly flat resting surface, conical under-surface. Narrow stem, globular body outset vertical rim with concave profile, ... |
| Skyphos with narrow torus ring foot, body with compound curve, lower portion contracted with nearly straight profile, curving to convex upper body, flaring lip. Two horizontal loop handles, slightly tilted ... Second quarter 4th c. BC |
| Krater with ring foot in two degrees: lower an inverted echinus, upper a flange. Lip in two degrees: lower is convex, upper is a double fillet. High full body sharply separated from foot, opening into ... |
| Chytra with slightly flattened bottom, ovoid body with max. diam. Below median at 0.045. Wheel groove at rim attachment. Flaring rim with inward beveled lip, conacave inside. Flange as downward sloping ... 1946/11/20 |
| Bottom slightly concave with rosette in relief and surrounded by double base-ring. Tongue pattern radiating from bottom to point on middle of bowl. Horizontal row of dots above tongue pattern, and raised ... |
| Articulated kantharos with flaring ring foot. Flat resting surface. Concave underside with nipple in center. Exterior of foot has profile wheel grooved in two degrees. Biconical body with angular carination ... 1947/03/05 |
| Articulated kantharos with flaring ring foot. Flat resting surface. Conical underside with nipple in center. Exterior of foot has profile wheel grooved in two degrees. Biconical body with rounded carination ... 1947/03/05 |
| Cyma kantharos with stem foot, flat resting surface and nippled conical undersurface, with moulded exterior in two degrees; wide lower with convex sloping side ending in tapered edge, upper high, narrow ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and concave undersurface, with moulded exterior in two degrees; narrow lower with convex sloping side ending in beveled edge, upper medium-thick beveled ... 1947/03/05;1947/03/06 |
| Cyma kantharos with wide body, lower almost globular and upper straight and almost vertical in profile, narrowing to a small everted tapered lip. Two vertical strap handles with rectangular thumb rest ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and concave undersurface, with moulded exterior in two degrees; wide lower with straight sloping side ending in beveled edge, high upper medium thin ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; narrow lower with convex sloping side ending in beveled edge, upper thin pointed ridge ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; wide and low lower with straight sloping side ending in beveled edge, upper wide, thick ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; wide lower with convex sloping side ending in tapered edge, upper medium-thin ridge with ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; narrow lower with convex sloping side ending in beveled edge, upper high ridge with ... 1947/03/05;1947/03/06 |
| Articulated kantharos with flaring ring foot. Resting surface bevelled. Flat underside. Exterior of foot has profile wheel grooved in two degrees. Biconical nearly globular body with rounded carination ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; wide lower with straight sloping side ending in beveled edge, upper high, narrow step ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and nippled conical undersurface, with moulded exterior in two degrees; narrow lower with convex sloping profile ending in beveled edge, upper very thin ... 1947/03/05;1947/03/06 |
| Articulated kantharos with flaring ring foot. Resting surface bevelled in to flat underside. Exterior of foot has convex profile. Biconical body with angular carintation set at approx. two-thirds the height ... 1947/03/05;1947/03/06 |
| Articulated kantharos with flaring ring foot. Flat resting surface. Concave underside with large nipple in center. Exterior of foot has profile wheel grooved in two degrees. Biconical nearly globular body ... 1947/03/05;1947/03/06 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; wide lower with convex sloping side ending in beveled edge, upper thick ring with square ... 1947/03/05;1947/03/06 |
| One piece kantharos with flaring ring foot with groove, trimmed along edge, flat resting surface, flat undersurface, body flares widely to median and contracts in a convex curve to the vertical fine ... 300 (GRE) |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; wide lower with convex sloping side ending in tapered edge, upper narrow, high step rising ... 1947/03/05;1947/03/06 |
| Calyx kantharos with stem offset from body by ring. Body with compound profile, bottom flares convex to nearly conical with nearly horizontal shoulder joining to upper part, which is set off by single ... First half of 3rd c. B.C. (Corinth VII.3 p. 74), 275-260 BC (Agora XXIX.1 pp. 250-51) |
| Cyma kantharos with stem foot, flat resting surface and convex undersurface, with moulded exterior in two degrees; high, wide lower with convex side ending in beveled edge, upper high ridge with pointed ... 1947/02/17 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with mouded exterior in two degrees; high, wide lower with straight sloping side and single groove running around its circumference, ... 1947/02/16 |
| Articulated kantharos with flaring ring foot. Resting surface bevelled to interior. Underside deeply concave with nipple in center. Exterior of foot has profile wheel grooved in two degrees. Biconical ... 1947/02/14 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; low, wide lower with convex sloping side ending in beveled edge, upper high ridge with ... 1947/02/17 |
| Cyma kantharos with stem foot, flat resting surface and conical undersurface, with moulded exterior in two degrees; high, wide lower with horizontal top and straight sloping profile ending in beveled ... 1947/02/17 |
| Cyma kantharos with stem foot, flat resting surface and convex undersurface, with molded exterior in two degrees; wide lower with convex sloping side ending in beveled edge, upper a thin ridge with square ... 1947/02/17 |
| Articulated kantharos with flaring ring foot. Resting surface bevelled to concave interior with nipple in center. Exterior profile of foot is wheel grooved in two degrees. Biconical body with angular carination ... 1947/02/19
1947/02/19;1947/03/12
1947/02/19;1947/03/12 |
| Articulated kantharos with flaring ring foot. Resting surface bevelled to concave underside. Biconical body with angular carination set at approx. two-thirds the height of the body. Lower walls convex ... 1947/02/19-20 |
| Articulated kantharos with flaring ring base. Resting surface tapered to convex underside with nipple in center. Exterior of foot has profile wheel grooved in two degrees. Biconical body with angular carination ... 1947/02/19-20 |
| Plate with flaring ring foot, flat resting surface, conical undersurface, straight flaring sides to flat rim with rounded lip. Black glaze overall interior and upper part exterior. Groove inside rim ... 1/4 2nd to interim period (Sarah James), 146 BC (GRE) |
|
|